Cisco A9K-SIP-700 Reference Guide

evi (PBB)
To enable PBB EVPN and set the EVI for the bridge, use the evi command in the L2VPN bridge group bridge
domain PBB-core configuration mode. To disable PBB EVPN and reset the EVI, use the no form of this
command.
evi evi-id
no evi evi-id
Syntax Description
Specifies the Ethernet VPN ID to set. The range is from 1 to 65534.
evi-id
Command Default
None.
Command Modes
L2VPN bridge group bridge domain PBB core configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The VPN ID must be unique globally per network.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to enable PBB EVPN and set the EVI for the bridge:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# pbb core
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pbb-core)# evi 2
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pbb-core)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
402
Provider Backbone Bridge Commands
evi (PBB)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English