port0 interface
To enable G.8032 for a specified ring port, use the port0 interface command in g8032 configuration port0
submode. To disable, use the no form of this command.
port 0 interface interface name
no port 0 interface interface name
Syntax Description
Any physical Ethernet or Bundle Ethernet interface. A physical port of the
local node connected to G.8032 ring.
interface name
Command Default
None
Command Modes
Ethernet ring g8032 configuration port0 submode
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows the output from the port0 interface command:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# ethernet ring g8032 g1
RP/0/RSP0/CPU0:router(config-l2vpn-erp)# port0 interface Bundle-Ether 555
RP/0/RSP0/CPU0:router(config-l2vpn-erp-port0)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
298
Multipoint Layer 2 Services Commands
port0 interface
To Next Page
Loading...
Need help?
General
