show nve peers
To display the network virtualization endpoint (NVE) peers configured on the router, use the show nve peers
command in EXEC mode.
show nve peers [interface nve nve-id| vni vni-id]
Syntax Description
Displays NVE peers of the specified NVE interface.
interface nve nve-id
Displays NVE peers of the specified VNIs.
vni vni-id
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 5.2.0
Usage Guidelines
The router learns about NVE peers through data plane traffic. Therefore, the show nve peers command output
displays NVE peers only after VXLAN traffic traverses through the router.
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
readtunnel
Examples
The following shows an example output of the show nve peers command.
RP/0/RSP0/CPU0:router# show nve peers
Interface Peer-IP VNI Up Time
nve1 1.1.1.2 1000 10h
nve2 1.1.1.3 2000 20h
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
680
VXLAN Commands
show nve peers
To Next Page
Loading...
Need help?
General
