show lpts pifib hardware entry optimized
To display a set of optimized entries that are combined as a single entry, inside the Ternary Content Addressable
Memory (TCAM), use the show lpts pifib hardware entry optimized command in EXEC mode.
show lpts pifib hardware entry optimized location
Syntax Description
Mandatory. The location of the line card where the interface is present.
location
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.1.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
readlpts
Examples
The following example shows the output of the show lpts pifib hardware entry optimizedcommand:
RP/0/RSP0/CPU0:router# show lpts pifib hardware entry optimized location 0/4/CPU0
Node: 0/4/CPU0:
----------------------------------------
Protocol - Layer4 Protocol; Intf - Interface in optimized list
Protocol laddr.Port, raddr.Port Intf VRF id State
---------- ------------------------- --------------- ------------ --------------------
IGMP 224.0.0.22.any , any.any Te0/4/0/0 * Uidb Set
Te0/4/0/1 * Uidb Set
224.0.0.22.any , any.any Te0/4/0/0 * Uidb Set
Te0/4/0/1 * Uidb Set
any.any , any.any Te0/4/0/0 * Uidb Set
Te0/4/0/1 * Uidb Set
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
670
Layer 2 Access List Commands
show lpts pifib hardware entry optimized
To Next Page
Loading...
Need help?
General
