leaveall-time (PBB)
To set the leave-all-time for all active ports, use the leaveall-time command in the flood optimization for
PBB over VPLS global configuration submode.
leaveall-time seconds
Syntax Description
Sets the minimum time in seconds for the leave-all timer parameter for all active
ports. Range is from 5 to 30 seconds.
seconds
Command Default
10 seconds
Command Modes
Flood optimization for PBB over VPLS global configuration submode.
Command History
ModificationRelease
This command was introduced.Release 5.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The leave-all timer parameter controls how often the leave-all messages are sent. This forces all the peers to
re-declare all the attributes, thereby replaying any registrations or deregistrations that may be lost.
Task ID
OperationTask ID
read, writeethernet-services
Examples
The following example shows how to set the leave-all time on all active ports:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# mmrp-flood-optimization
RP/0/RSP0/CPU0:router(config-mmrp-flood-opt)# leaveall-time 20
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
412
Provider Backbone Bridge Commands
leaveall-time (PBB)
To Next Page
Loading...
Need help?
General
