pw-routing
To enable pseudowire routing capabilities and enter the pseudowire routing configuration submode, use the
pw-routing command in the L2VPN routing configuration submode.
pw-routing
Syntax Description
This command has no keywords or arguments.
Command Default
None.
Command Modes
L2VPN routing configuration submode
Command History
ModificationRelease
This command was introduced.Release 5.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
The following example shows how to enable pseudowire routing capabilities:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)#router-id 2.2.2.2
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-routing
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# global-id 1000
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# bgp
RP/0/RSP0/CPU0:router(config-l2vpn-pwr-bgp)# rd 192.168.1.3:10
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
121
Point to Point Layer 2 Services Commands
pw-routing
To Next Page
Loading...
Need help?
General
