transport rsvp-te
To enable RSVP-TE as transport on a VFI and to enter L2VPN bridge group bridge domain VFI multicast
P2MP RSVP - TE configuration mode, use the transport rsvp-te command in L2VPN bridge group bridge
domain VFI multicast P2MP configuration mode. To return to P2MP mode, use the no form of this command.
transport rsvp-te [attribute-set]
no transport rsvp-te [attribute-set]
Syntax Description
Specifies the TE attribute set parameters.[attribute-set]
Command Default
Command Modes
L2VPN bridge group bridge domain VFI multicast P2MP configuration
Command History
ModificationRelease
This command was introduced.Release 5.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to enable RSVP-TE as transport on a VFI:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi v1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# multicast p2mp
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi-p2mp)# transport rsvp-te
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi-p2mp-te)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
376
Multipoint Layer 2 Services Commands
transport rsvp-te
To Next Page
Loading...
Need help?
General
