ipv6 address (LxVPN)
To set the IPv6 address of the tunnel interface, use the ipv6 address command in interface configuration
mode. To remove the IPv6 addresses, use the no form of this command.
ipv6 {address zone {prefix length| link-local} [route-tag value]| zone/length [route-tag value]}
no ipv6 {address zone {prefix length| link-local} [route-tag value]| zone/length [route-tag value]}
Syntax Description
Specifies the IPv6 address of the interface.zone
Specifies the length of the IPv6 address prefix, in bits. The range is from
1 to 128.
prefix length
Specifies the link-local address.link-local
Specifies the tag associated with the address.route-tag
Tag value. The range is from 1 to 4294967295.
value
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writenetwork
read, writeinterface
read, writeipv6
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
37
Generic Routing Encapsulation Commands
ipv6 address (LxVPN)
To Next Page
Loading...
Need help?
General
