withdraw (VPLS)
To disable MAC address withdrawal for a specified bridge domain, use the withdraw command in L2VPN
bridge group bridge domain MAC configuration mode. To enable this feature, use the no form of this command
withdraw {access-pw disable | disable}
no withdraw {access-pw disable | disable }
Syntax Description
Disables the sending of MAC withdraw messages to access pseudowires.access-pw disable
Disables MAC address withdrawal.disable
Command Default
By default, MAC address withdrawal is enabled.
Command Modes
L2VPN bridge group bridge domain MAC configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
The access-pw disable keyword was added.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to enable disable MAC withdrawal:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)# withdraw disable
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
382
Multipoint Layer 2 Services Commands
withdraw (VPLS)
To Next Page
Loading...
Need help?
General
