pw-grouping
To enable Pseudowire Grouping, use the pw-grouping command in L2vpn configuration submode. To return
to the default behavior, use the no form of this command.
pw-grouping
no pw-grouping
Syntax Description
Enables Pseudowire Grouping.pw-grouping
Command Default
PW-grouping is disabled by default.
Command Modes
L2VPN configuration submode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows the sample output of pw-grouping configuration in L2VPN configuration submode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-grouping
Related Commands
DescriptionCommand
Enters L2VPN configuration mode.l2vpn, on page 100
Displays L2VPN informationshow l2vpn, on page 158
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
133
Point to Point Layer 2 Services Commands
pw-grouping
To Next Page
Loading...
Need help?
General
