aging (VPLS)
To enter the MAC aging configuration submode to set the aging parameters such as time and type, use the
aging command in L2VPN bridge group bridge domain configuration mode. To return to the default value
for all parameters that are attached to this configuration submode, use the no form of this command.
aging
no aging
Syntax Description
This command has no keywords or arguments.
Command Default
No defaults are attached to this parameter since it is used as a configuration submode. See defaults that are
assigned to the time (VPLS), on page 374 and the type (VPLS), on page 378 parameters.
Command Modes
L2VPN bridge group bridge domain MAC configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the aging command to enter L2VPN bridge group bridge domain MAC aging configuration mode.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to enter MAC aging configuration submode and to set the MAC aging
time to 120 seconds:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)# aging
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac-aging)# time 120
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
234
Multipoint Layer 2 Services Commands
aging (VPLS)
To Next Page
Loading...
Need help?
General
