protocol l2tpv3
To configure Layer 2 Tunneling Protocol Version 3 (L2TPv3) as the signaling protocol for a pseudowire
class, use the protocol l2tpv3 command in L2VPN pseudowire class encapsulation L2TPv3 configuration
mode. To disable L2TPv3 as the signaling protocol for a pseudowire class, use the no form of this command.
protocol l2tpv3[class class_name]
no protocol l2tpv3[class class_name]
Syntax Description
Specifies the L2TPv3 class.class
The L2TPv3 class name.
class_name
Command Default
None
Command Modes
L2VPN pseudowire class encapsulation L2TPv3 configuration
Command History
ModificationRelease
This command was introducedRelease 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
All L2VPN configurations can be deleted using the no l2vpn command.Note
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to set the encapsulation and protocol to L2TPv3:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-class kanata01
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
122
Point to Point Layer 2 Services Commands
protocol l2tpv3
To Next Page
Loading...
Need help?
General
