backup disable (L2VPN)
To specify how long a backup pseudowire should wait before resuming primary pseudowire operation after
the failure with primary pseudowire has been cleared, use the backup disable command in L2VPN pseudowire
class configuration mode. To disable this feature, use the no form of this command.
backup disable {delay value| never}
no backup disable {delay value| never}
Syntax Description
Specifies the number of seconds that elapse after the failure with primary pseudowire
has been cleared before the Cisco IOS XR software attempts to activate the primary
pseudowire.
The range, in seconds, is from 0 to 180. The default is 0.
delay value
Specifies that the secondary pseudowire does not fall back to the primary pseudowire if
the primary pseudowire becomes available again, unless the secondary pseudowire fails.
never
Command Default
The default disable delay is the value of 0, which means that the primary pseudowire is activated immediately
when it comes back up.
Command Modes
L2VPN pseudowire class configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
68
Point to Point Layer 2 Services Commands
backup disable (L2VPN)
To Next Page
Loading...
Need help?
General
