identifier
To set the Ethernet segment identifier value of an interface, use the identifier command in the EVPN interface
Ethernet-segment configuration mode. To delete the Ethernet segment identifier value, use the no form of
this command.
identifier system-priority priority-value system-id system-id
no identifier system-priority priority-value system-id system-id
Syntax Description
Specifies the CE system priority (LACP) .system-priority
Specifies the LACP system-priority value. The range is from 0 to ffff.
priority-value
Specifies the CE system ID (LACP).system-id
Specifies the LACP system ID in the H.H.H format.
system-id
Command Default
None.
Command Modes
EVPN interface Ethernet segment configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use this command to overwrite computed Ethernet segment identifier value or to set Ethernet segment identifier
value of an interface which is not a bundle. The concatenated value is unique per PE.
Task ID
OperationTask ID
read, writel2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
407
Provider Backbone Bridge Commands
identifier
To Next Page
Loading...
Need help?
General
