Examples
This example shows how to set the Ethernet segment identifier value of an interface in the EVPN interface
Ethernet segment configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
RP/0/RSP0/CPU0:router(config-evpn-ac)# ethernet segment
RP/0/RSP0/CPU0:router(config-evpn-ac-es)# identifier system-priority 2 system-id 1.1.1
Related Commands
DescriptionCommand
Enters EVPN interface ethernet segment configuration mode.ethernet-segment, on page 396
Sets the load balancing mode of a physical port or bundle to
active-active.
load-balancing-mode, on page 415
Specifies the list of service identifiers as active and standby
services.
service-carving, on page 431
Configures the backbone source MAC address.backbone-source-mac, on page 387
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
408
Provider Backbone Bridge Commands
identifier
To Next Page
Loading...
Need help?
General
