spanning-tree repag
To enter the Resilient Ethernet Protocol Access Gateway (REPAG) configuration submode, use the
spanning-tree repag command in global configuration mode.
spanning-tree repag protocol instance identifier
Syntax Description
String of a maximum of 255 characters that identifies the protocol
instance.
protocol instance identifier
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Refer to the Implementing Multiple Spanning Tree Protocol module of the Cisco ASR 9000 Series Aggregation
Services Router L2VPN and Ethernet Services Configuration Guide for more information.
Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to enter the REPAG configuration mode:
RP/0/RSP0/CPU0:router(config)# spanning-tree repag a
RP/0/RSP0/CPU0:router(config-repag)#
Related Commands
DescriptionCommand
Enables Resilient Ethernet Protocol (REP) Access Gateway
debugging commands.
debug spanning-tree repag packet, on page
493
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
633
Multiple Spanning Tree Protocol Commands
spanning-tree repag
To Next Page
Loading...
Need help?
General
