provider-bridge (MSTAG/REPAG)
To place the current instance of the protocol in 802.1ad mode, use the provider-bridge command in MSTAG
or REPAG interface configuration submode.
provider-bridge
Syntax Description
This command has no keywords or arguments.
Command Default
The default value is FALSE.
Command Modes
MSTAG interface configuration, REPAG interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to use the provider-bridge command:
RP/0/RSP0/CPU0:router(config-mstag-if)# provider-bridge
Related Commands
DescriptionCommand
Enables MSTAG packet debugging.debug spanning-tree mstag packet, on page
483
Enables Resilient Ethernet Protocol (REP) Access Gateway
debugging commands.
debug spanning-tree repag packet, on page
493
Enter the MSTAG interface configuration submode, and enables
MSTAG for the specified port.
interface (MSTAG/REPAG), on page 523
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
566
Multiple Spanning Tree Protocol Commands
provider-bridge (MSTAG/REPAG)
To Next Page
Loading...
Need help?
General
