show l2vpn process fsm
To display the status of the l2vpn process finite state machine, use the show l2vpn process fsm command in
EXEC mode. It displays the current process role and state, NSR status, ISSU status, role change status, and
status of collaborators.
show l2vpn process fsm [location| standby]
Syntax Description
(Optional) Displays non-stop routing information for the specified location.location
(Optional) Displays Standby node specific information.standby
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 6.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
readl2vpn
Examples
The following example displays output for the show l2vpn process fsm command:
RP/0/RSP0/CPU0:router# show l2vpn process fsm
Mon May 16 10:20:30.967 PDT
L2VPN Process FSM
Current process role : Primary Active (Master)
Current process state : Run
S/w install in progress : No
NSR Status:
NSR Ready : No
Last NSR Withdraw Time : Mon May 16 10:19:58 PDT 2016 (00:00:33 ago)
Standby Connected : No
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
191
Point to Point Layer 2 Services Commands
show l2vpn process fsm
To Next Page
Loading...
Need help?
General
