routed
To specify the bridge domain L3 interface, use the routed command in L2VPN bridge-group bridge-domain
configuration submode. To revert, use the no form of the command.
routed interface BVI BVI interface number
no routed interface BVI BVI interface number
Syntax Description
Bridge domain L3 interface.interface
Bridge-Group Virtual Interface.BVI
BVI interface number. The range is 1-65535.
BVI interface number
Command Default
None
Command Modes
L2VPN bridge-group bridge-domain configuration submode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
The example shows how to specify the L3 bridge domain interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group bg1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bd1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# routed interface BVI 100
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
311
Multipoint Layer 2 Services Commands
routed
To Next Page
Loading...
Need help?
General
