Related Commands
DescriptionCommand
Validates Address Resolution Protocol (ARP) packets in a network.dynamic-arp-inspection, on page 77
Enables source IP address filtering on a layer 2 port.ip-source-guard, on page 90
Enters L2VPN bridge group bridge domain MAC configuration
mode.
mac (VPLS), on page 277
Adjusts the maximum packet size or maximum transmission unit
(MTU) size for the bridge domain.
mtu (VPLS), on page 289
Adds an access pseudowire port to a bridge domain or a pseudowire
to a bridge virtual forwarding interface (VFI).
neighbor (VPLS), on page 293
Configures the provider backbone bridge core or edge.pbb, on page 420
Shuts down a bridge domain to bring the bridge and all attachment
circuits and pseudowires under it to admin down state.
shutdown (Bridge Domain), on page 361
Configures virtual forwarding interface (VFI) parameters.vfi (VPLS), on page 380
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
312
Multipoint Layer 2 Services Commands
routed
To Next Page
Loading...
Need help?
General
