bandwidth
To set the tunnel interface bandwidth, use the bandwidth command in interface configuration mode. To undo
the tunnel interface bandwidth that is set, use the no form of this command.
bandwidth kbps
no bandwidth kbps
Syntax Description
Interface bandwidth in kilobits per second (kbps). The range is from 0 to 4294967295.
The default value is 100.
kbps
Command Default
None
Command Modes
interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeinterface
Examples
This example shows how to set the bandwidth of the tunnel interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface tunnel-ip 6677
RP/0/RSP0/CPU0:router(config-if)# bandwidth 56789
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
32
Generic Routing Encapsulation Commands
bandwidth
To Next Page
Loading...
Need help?
General
