show ethernet mvrp mad
To display the current state of the Multiple Registration Protocol (MRP) Attribute Declaration (MAD)
component on a port, for each active attribute value (VID), use the show ethernet mvrp mad command in
EXEC mode.
show ethernet mvrp mad [brief] [interface interface-name] [vlan vlan-id]
Syntax Description
(Optional) Displays a brief view.brief
(Optional) Displays the MVRP state for the given subinterface or base
interface name.
interface
(Optional) Displays the interface name.
interface-name
(Optional) Displays information for a particular VLAN. The range is
between 0 to 4094.
vlan vlan-id
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readethernet-services
Examples
The following sample output is from the show ethernet mvrp mad command:
RP/0/RSP0/CPU0:router# show ethernet mvrp mad interface GigabitEthernet 0/1/0/1
GigabitEthernet0/1/0/1
Participant Type: Full; Point-to-Point: Yes
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
579
Multiple Spanning Tree Protocol Commands
show ethernet mvrp mad
To Next Page
Loading...
Need help?
General
