static-mac-address
To map a customer destination MAC address to backbone destination MAC address, use the static-mac-address
command in the PBB edge configuration mode. To return to the default behavior, use the no form of this
command.
static-mac-address cust-mac-address bmac bmac-mac-address
no static-mac-address cust-mac-address bmac bmac-mac-address
Syntax Description
Customer destination MAC address in hexadecimal format.
cust-mac-address
Specifies that the static backbone MAC address must be mapped with the
customer MAC address.
bmac
Static backbone MAC address in hexadecimal format.
bmac-mac-address
Command Default
None
Command Modes
PBB edge configuration mode
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to map the customer MAC address with the backbone MAC address:
interface GigabitEthernet0/0/0/0.1 l2transport encapsulation dot1q 10 !
interface GigabitEthernet0/0/0/0.2 l2transport encapsulation dot1q 2 !
interface GigabitEthernet0/0/0/1
shutdown
!
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
456
Provider Backbone Bridge Commands
static-mac-address
To Next Page
Loading...
Need help?
General
