Cisco A9K-SIP-700 Reference Guide

interface GigabitEthernet0/0/0/2
shutdown
!
interface GigabitEthernet0/0/0/3
shutdown
!
interface GigabitEthernet0/0/0/4
shutdown
!
l2vpn
bridge group bg12
bridge-domain bd1
interface GigabitEthernet0/0/0/0.1
static-mac-address 0002.0003.0004
!
interface GigabitEthernet0/0/0/0.2
!
pbb edge i-sid 1000 core-bridge bd2
static-mac-address 0006.0007.0008 bmac 0004.0005.0006
!
!
!
!
end
!
The following example shows the output of the show l2vpn bridge-domain command:
##sh l2vpn bridge-domain m mac-address mroute
Mac Address Type Learned from/ LC learned Mapped to
Filtered on Resync Age
------------------------------------------------------------------------------------------
0002.0003.0004 static Gi0/0/0/0.1 N/A N/A N/A
0006.0007.0008 static BD id: 0 N/A N/A 0004.0005.0006
To resynchronize the MAC table from the network processors, use the l2vpn resynchronize forwarding
mac-address-table location <r/s/i> command.
Note
Related Commands
DescriptionCommand
Establishes a bridge domain, and enters L2VPN bridge group bridge
domain configuration mode.
bridge-domain (VPLS), on page 240
Creates a bridge group so that it can contain bridge domains and
then to assign network interfaces to the bridge domain.
bridge group (VPLS), on page 242
Configures the provider backbone bridge core or edge.pbb, on page 420
Enters L2VPN configuration mode.l2vpn, on page 100
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
457
Provider Backbone Bridge Commands
static-mac-address

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English