ethernet-services access-list
To define an Ethernet services (Layer 2) access list by name, use the ethernet-services access-list command
in global configuration mode. To remove all entries in an Ethernet services access list, use the no form of the
command.
ethernet-services access-list access-list-name
no ethernet-services access-list access-list-name
Syntax Description
Name of the Ethernet services access list. The name cannot contain a spaces
or quotation marks, but can include numbers.
access-list-name
Command Default
No Ethernet services access list is defined.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The ethernet-services access-list command places the router in access list configuration mode, in which the
denied or permitted access conditions must be defined with the deny (ES ACL) or permit (ES ACL) command.
Use the resequence access-list ethernet-service, on page 660 command if you need to add a permit or deny
statement between consecutive entries in an existing Ethernet services access lists.
Task ID
OperationsTask ID
read, writeacl
Examples
The following example shows how to define an Ethernet services access list named L2ACL1:
RP/0/RSP0/CPU0:router(config)# ethernet-services access-list L2ACL1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
655
Layer 2 Access List Commands
ethernet-services access-list
To Next Page
Loading...
Need help?
General
