description (GRE)
To specify the description of any interface, use the description command in the interface configuration mode.
To undo the specified description, use the no form of the command.
description description-name
no description
Syntax Description
Description of the Interface.
description-name
Command Default
None
Command Modes
Interface Configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeinterface
Examples
The following output shows how to specify the description of an interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface tunnel-ip 789
RP/0/RSP0/CPU0:router(config-if)# description Interface
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
33
Generic Routing Encapsulation Commands
description (GRE)
To Next Page
Loading...
Need help?
General
