transmit hold-count
To set the transmit hold count performance parameter, use the transmit hold-count command in MSTP
configuration submode.
transmit hold-count count
Syntax Description
Bridge transmit hold count. Range is 1 to 10.
count
Command Default
count: 6
Command Modes
MSTP configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to set the bridge transmit hold-count parameter to 8:
RP/0/RSP0/CPU0:router(config)# spanning-tree mst A
RP/0/RSP0/CPU0:router(config-mstp)# transmit hold-count 8
Related Commands
DescriptionCommand
Enables debugging for sent and received MSTP packets.debug spanning-tree mst packet, on page 479
Enables debugging protocol-state changes such as port role
or state changes, topology change notification.
debug spanning-tree mst protocol-state, on
page 481
Enters the MSTP configuration submodespanning-tree mst, on page 623
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
637
Multiple Spanning Tree Protocol Commands
transmit hold-count
To Next Page
Loading...
Need help?
General
