ipv4 address
To set the IPv4 address of the tunnel interface, use the ipv4 address command in interface configuration
mode. To remove the IPv4 addresses, use the no form of this command.
ipv4 address prefix subnet mask [route-tag value| secondary [route-tag value]]
no ipv4 address prefix subnet mask [route-tag value| secondary [route-tag value]]
Syntax Description
IPv4 address of the interface.
prefix
Subnet mask of the interface.
subnet mask
Specifies the tag associated with the IP address.route-tag
Tag value.
value
Specifies the secondary IPV4 address.secondary
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writenetwork
read, writeacl
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
34
Generic Routing Encapsulation Commands
ipv4 address
To Next Page
Loading...
Need help?
General
