show nve interface
To display the network virtualization endpoint (NVE) interface information, use the show nve interface
command in EXEC mode.
show nve interface [detail| nve nve-id]
Syntax Description
Displays detailed information about NVE interfaces.detail
Displays information only about the specified NVE interface.
nve nve-id
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 5.2.0
The show command output was enhanced to display VXLAN anycast
gateway parameters.
Release 5.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
readinterface
Examples
This is the sample output for show interface nve command enhanced to display VXLAN anycast gateway
parameters.
RP/0/RSP0/CPU0:router(config)# show interface nve100 detail
Interface: nve100 State: Up Encapsulation: VxLAN
Source Interface: Loopback1 (primary: 1.1.1.1)
Source Interface State: Up
NVE Flags: 0x1, Admin State: Up, Interface Handle 0xba0
UDP Port: 4789
Anycast Source Interface: Loopback100 (primary: 100.1.1.1)
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
678
VXLAN Commands
show nve interface
To Next Page
Loading...
Need help?
General
