debug spanning-tree pvstag packet
To enable packet debugging for sent and received PVSTAG packets, use the debug spanning-tree pvstag
packet command in EXEC mode. To disable debugging, use the no form of this command.
debug spanning-tree pvstag packet {brief| full} {sent| received} [interface interface-name]
no debug spanning-tree pvstag packet {brief| full} {sent| received} [interface interface-name]
Syntax Description
Enables brief debugging output.brief
Enables full debugging output.full
Indicates packets sent.sent
Indicates packets received.received
{Optional} Filters by interface.
Physical interface or a virtual interface.
Use the show interfaces command to see a list of all possible interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface interface-name
Command Default
If an interface is not specified, then debug is enabled for all interfaces.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
debugethernet-services
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
491
Multiple Spanning Tree Protocol Commands
debug spanning-tree pvstag packet
To Next Page
Loading...
Need help?
General
