copy access-list ethernet-service
To create a copy of an existing Ethernet services access list, use the copy access-list ethernet-services
command in EXEC mode.
copy access-list ethernet-service source-acl destination-acl
Syntax Description
Name of the access list to be copied.
source-acl
Name of the destination access list where the contents of the source-acl
argument is copied.
destination-acl
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the copy access-list ethernet-service command to copy a configured Ethernet services access list. Use
the source-acl argument to specify the access list to be copied and the destination-acl argument to specify
where to copy the contents of the source access list. The destination-acl argument must be a unique name; if
the destination-acl argument name already exists for an access list, the access list is not copied. The copy
access-list ethernet-service command checks that the source access list exists then checks the existing list
names to prevent overwriting existing access lists.
Task ID
OperationsTask ID
read, writeacl
executefilesystem
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
648
Layer 2 Access List Commands
copy access-list ethernet-service
To Next Page
Loading...
Need help?
General
