interface nve
To create a network virtualization endpoint (NVE) interface and enter the NVE interface configuration mode,
use the interface nve command in Global Configuration mode. To remove the NVE interface, use the no
form of this command.
interface nve nve-id
Syntax Description
The NVE interface ID. It can take values from 1 to 65535.
nve-id
Command Default
None
Command Modes
Global Configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeinterface
Examples
The following example shows how to create an NVE interface and enter the NVE interface configuration
mode.
RP/0/RSP0/CPU0:router(config)# interface nve 1
RP/0/RSP0/CPU0:router(config-if)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
673
VXLAN Commands
interface nve
To Next Page
Loading...
Need help?
General
