multicast p2mp
To enable point to multi-point pseudowire in a VFI and to enter L2VPN bridge group bridge domain VFI
multicast P2MP configuration mode, use the multicast p2mp command in L2VPN bridge group bridge
domain VFI configuration mode. To return to a VFI mode, use the no form of this command.
multicast p2mp [signaling-protocol | transport]
no multicast p2mp [signaling-protocol | transport]
Syntax Description
Specifies the signaling protocol selectionsignaling-protocol
Specifies the transport type selectiontransport
Command Default
None
Command Modes
L2VPN bridge group bridge domain VFI configuration
Command History
ModificationRelease
This command was introduced.Release 5.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to configure a point to multi-point pseudowire in a VFI:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi v1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# multicast p2mp
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi-p2mp)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
291
Multipoint Layer 2 Services Commands
multicast p2mp
To Next Page
Loading...
Need help?
General
