transport mode (L2VPN)
To configure L2VPN pseudowire class transport mode, use the transport mode command in L2VPN
pseudowire class MPLS encapsulation mode. To disable the L@VPN pseudowire class transport mode
configuration, use the no form of this command.
transport mode {ethernet| vlan passthrough }
no transport mode {ethernet| vlan passthrough }
Syntax Description
Configures Ethernet port mode.ethernet
Configures VLAN tagged mode.vlan
Enables the pseudowires to pass through the incoming tags.
passthrough
Command Default
None
Command Modes
L2VPN pseudowire class MPLS encapsulation
Command History
ModificationRelease
This command was introduced.Release 3.7.2
The variable passthrough was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
All L2VPN configurations can be deleted using the no l2vpn command.Note
Task ID
OperationsTask ID
read, writel2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
221
Point to Point Layer 2 Services Commands
transport mode (L2VPN)
To Next Page
Loading...
Need help?
General
