show access-list ethernet-service usage pfilter
To identify the modes and interfaces on which a particular ACL is applied, use the show access-list
ethernet-service usage pfilter command in EXEC mode. Information displayed includes the application of
all or specific ACLs, the interfaces on which they have been applied and the direction in which they are
applied.
show access-list ethernet-services [ access-list-name ] usage pfilter location {location| all}
Syntax Description
(Optional) Name of a specific Ethernet services access list. The name cannot
contain a spaces or quotation marks, but can include numbers.
access-list-name
Interface card on which the access list information is needed.location
Fully qualified location specification.
location
Displays packet filtering usage for all interface cards.all
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeacl
Examples
The following example shows how to display packet filter usage at a specific location:
RP/0/RSP0/CPU0:router# show access-list ethernet-services usage pfilter location 0/0/cpu0
pfilter location 0/0/cpu0
Interface : GigabitEthernet0/0/0/9
Input ACL : l2_acl
Output ACL : N/A
Interface : GigabitEthernet0/0/0/30
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
668
Layer 2 Access List Commands
show access-list ethernet-service usage pfilter
To Next Page
Loading...
Need help?
General
