hello-time (Access Gateway)
To configure the frequency of sending BPDUs on this interface, use the hello-time command in MSTAG
interface configuration, REPAG Interface configuration, PVSTAG VLAN configuration, or PVRSTAG VLAN
configuration submode.
hello-time seconds
Syntax Description
Hello time in seconds. Range is 1 to 2.
seconds
Command Default
seconds: 2
Command Modes
MSTAG interface configuration, REPAG Interface configuration, PVSTAG VLAN configuration, PVRSTAG
VLAN configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
This command was supported in the PVSTAG VLAN configuration
and PVRSTAG VLAN configuration mode.
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeinterface ( for MSTAG/REPAG)
read, writeethernet-services ( for PVSTAG/PVRSTAG)
Examples
The following example shows how to set the port hello time to 1:
RP/0/RSP0/CPU0:router(config-mstag-if)# hello-time 1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
511
Multiple Spanning Tree Protocol Commands
hello-time (Access Gateway)
To Next Page
Loading...
Need help?
General
