flood mode
To change the flood mode from Bandwidth Optimized to Convergence Optimized, use the flood mode
convergence-optimized command in the l2vpn bridge group bridge domain configuration mode. To return
the bridge to normal flooding behavior (when all unknown unicast, broadcast and multicast packets are flooded
over other bridge domain network interfaces), use the no form of this command.
flood mode {resilience-optimized| convergence-optimized}
no flood mode {resilience-optimized| convergence-optimized}
Syntax Description
Configures bridge to use Resilience Optimized mode.resilience-optimized
Configures bridge to use Convergence Optimized mode.convergence-optimized
Command Default
The bridge domain operates in the Bandwidth Optimized Mode.
Command Modes
l2vpn bridge group bridge domain configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The flood mode command allows you to change the flood optimization mode to either Convergence Optimized
mode or Resilience Optimized mode. The Convergence Optimized mode floods all traffic to all line cards;
all unknown unicast packets, all broadcast packets, and all multicast packets are flooded over all other bridge
domain network interfaces. The Resilience Optimized Mode works like Bandwidth Optimized mode, except
that it floods traffic to both primary and backup FRR links for a Pseudowire.
Task ID
OperationsTask ID
read, writel2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
79
Point to Point Layer 2 Services Commands
flood mode
To Next Page
Loading...
Need help?
General
