spanning-tree pvrstag
To enter the Per VLAN Rapid Spanning Tree Access Gateway (PVRSTAG) configuration submode, use the
spanning-tree pvrstag command in global configuration mode.
spanning-tree pvrstag protocol instance identifier
Syntax Description
String of a maximum of 255 characters that identifies the protocol
instance.
protocol instance identifier
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Refer to the Implementing Multiple Spanning Tree Protocol module of the Cisco ASR 9000 Series Aggregation
Services Router L2VPN and Ethernet Services Configuration Guide for more information.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to enter the PVRSTAG configuration submode:
RP/0/RSP0/CPU0:router(config)# spanning-tree pvrstag a
RP/0/RSP0/CPU0:router(config-pvrstag)#
Related Commands
DescriptionCommand
Enables packet debugging for sent and received PVRSTAG packets.debug spanning-tree pvrstag packet, on
page 489
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
629
Multiple Spanning Tree Protocol Commands
spanning-tree pvrstag
To Next Page
Loading...
Need help?
General
