bgp
To enable the BGP pseudowire routing capabilities and enter the bgp configuration submode, use the bgp
command in the L2VPN routing configuration submode.
bgp
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
L2VPN routing configuration submode
Command History
ModificationRelease
This command was introduced.Release 5.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Examples
The following example shows how to enable BGP pseudowire routing capabilities.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# router 2.2.2.2
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-routing
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# global-id 1000
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# bgp
RP/0/RSP0/CPU0:router(config-l2vpn-pwr-bgp)# rd 192.168.1.3:10
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
65
Point to Point Layer 2 Services Commands
bgp
To Next Page
Loading...
Need help?
General
