edge-mode
To enable MSTAG edge mode for Multiple Spanning Tree Instance (MSTI), use the edge-mode command
in MSTAG instance configuration submode. Use the no form of this command to disable the MSTAG edge
mode.
edge-mode
no edge-mode
Syntax Description
This command has no keywords or arguments.
Command Default
Disabled
Command Modes
MSTAG instance configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeethernet-services
Examples
This example shows the output from the edge-mode command:
RP/0/RSP0/CPU0:router#configure
RP/0/RSP0/CPU0:router(config)#spanning-tree mstag A
RP/0/RSP0/CPU0:router(config-mstag)#interface GigabitEthernet 0/2/0/1.1
RP/0/RSP0/CPU0:router(config-mstag-if)#instance 100
RP/0/RSP0/CPU0:router(config-mstag-if-inst)#edge-mode
RP/0/RSP0/CPU0:router(config-mstag-if-inst)#
Related Commands
DescriptionCommand
Enters the MST Access Gateway configuration submode.spanning-tree mstag, on page 625
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
495
Multiple Spanning Tree Protocol Commands
edge-mode
To Next Page
Loading...
Need help?
General
