shutdown (VFI)
To disable virtual forwarding interface (VFI), use the shutdown command in L2VPN bridge group bridge
domain VFI configuration mode. To re-enable VFI, use the no form of this command.
shutdown
no shutdown
Syntax Description
This command has no keywords or arguments.
Command Default
By default, the VFI is not shutdown.
Command Modes
L2VPN bridge group bridge domain VFI configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to disable VFI:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi v1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# shutdown
Related Commands
DescriptionCommand
Establishes a bridge domain, and enters L2VPN bridge group bridge
domain configuration mode.
bridge-domain (VPLS), on page 240
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
363
Multipoint Layer 2 Services Commands
shutdown (VFI)
To Next Page
Loading...
Need help?
General
