debug mmrp-flood-optimization packets
To debug the flood optimization for PBB VPLS feature at the packet level, use the debug
mmrp-flood-optimization packets command in the EXEC mode.
debug mmrp-flood-optimization packets {brief| full| hexdump} [direction {received| sent}] [pw neighbor
pw-id]
Syntax Description
Brief packet debug.brief
Full packet debug.full
Raw packet output.hexdump
Restricts output to a packet direction.direction
Packets received.received
Packets sent.sent
Specifies a pseudowire to filter.pw
IP address of the neighbor
neighbor
Pseudowire ID.
pw-id
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 5.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
393
Provider Backbone Bridge Commands
debug mmrp-flood-optimization packets
To Next Page
Loading...
Need help?
General
