show l2vpn nsr
To display the status of l2vpn non-stop routing, use the show l2vpn nsr command in EXEC mode.
show l2vpn nsr [location| standby]
Syntax Description
(Optional) Displays non-stop routing information for the specified location.location
(Optional) Displays Standby node specific information.standby
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.3.0
The show command output was updated.Release 6.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
readl2vpn
Examples
The following example displays output for the show l2vpn nsr command:
RP/0/RSP0/CPU0:router# show l2vpn nsr
Mon May 30 19:32:01.045 UTC
L2VPN NSR information
NSR Status:
NSR Ready : Fri May 27 10:50:59 UTC 2016 (3d08h ago)
Last NSR Withdraw Time : Fri May 27 10:50:59 UTC 2016 (3d08h ago)
Standby Connected : Fri May 27 10:50:59 UTC 2016 (3d08h ago)
IDT Done : Fri May 27 10:50:59 UTC 2016 (3d08h ago)
Number of XIDs sent : Virtual AC: 0
AC : 1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
189
Point to Point Layer 2 Services Commands
show l2vpn nsr
To Next Page
Loading...
Need help?
General
