programming
To configure the programming timer, use the programming command in the EVPN Timers configuration
mode. To delete the programming timer, use the no form of this command.
programming microseconds
no programming microseconds
Syntax Description
Specifies the value in microseconds ranging from 0 to 100000 seconds. The
default value is 1500 microseconds.
microseconds
Command Default
None.
Command Modes
EVPN Timers configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Every time the ES Manager runs DF election, it starts a programming timer to account for the time needed
by the hardware to apply the new carving. At the expiry time, the next ES route object is processed or carved,
restarting the timer.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to configure the programming timer in the EVPN Timers configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# timers
RP/0/RSP0/CPU0:router(config-evpn-timers)# programming 5000
RP/0/RSP0/CPU0:router(config-evpn-timers)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
425
Provider Backbone Bridge Commands
programming
To Next Page
Loading...
Need help?
General
