Cisco A9K-SIP-700 Reference Guide

rd (L2VPN)
To configure BGP route distinguisher, use the rd command in the L2VPN pseudowire routing bgp configuration
submode or the L2VPN bridge domain VFI autodiscovery bgp submode or the L2VPN cross-connect mp2mp
autodiscovery bgp sub-mode, as applicable.
rd {ASN : index| ipv4-address : index}
Syntax Description
Specifies the 2-byte or 4-byte
autonomous system number.
ASN
Specifies the index value. If the
ASN is 2-byte, then the index value
is 4-byte. If the ASN is 4-byte or
the index is preceded by an IPv4
address, then the index value is
2-byte.
index
Indicates the IP address (4 bytes).
The index value associated with the
IP address is 2-byte.
ipv4-address
Command Default
Default value is auto-generated in the format IPv4 address : nn; where, IPv4 address is set to the BGP router-id
for all features or to L2VPN router-id for pseudowire routing only, and nn is the index value that is
auto-generated.
Command Modes
L2VPN pseudowire routing BGP configuration submode
L2VPN bridge domain VFI autodiscovery BGP submode
L2VPN cross-connect mp2mp autodiscovery BGP submode
Command History
ModificationRelease
This command is introduced for the
L2VPN bridge domain VFI
autodiscovery BGP and L2VPN
cross-connect mp2mp
autodiscovery BGP submodes.
Release 3.7.2
This command is introduced for the
L2VPN pseudowire routing BGP
configuration submode.
Release 5.1.2
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
136
Point to Point Layer 2 Services Commands
rd (L2VPN)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English