ModificationRelease
For the L2VPN bridge domain VFI
autodiscovery BGP and L2VPN
cross-connect mp2mp
autodiscovery BGP submodes, the
index value associated with the IP
address can take values higher than
32767 in the range from 0 to 65535.
Release 5.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
The following example shows how to configure BGP route distinguisher.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)#router-id 2.2.2.2
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-routing
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# global-id 1000
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# bgp
RP/0/RSP0/CPU0:router(config-l2vpn-pwr-bgp)# rd 192.168.1.3:10
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
137
Point to Point Layer 2 Services Commands
rd (L2VPN)
To Next Page
Loading...
Need help?
General
