Input ACL : N/A
Output ACL : i
The following example shows the results of the command for a specific ACL:
RP/0/RSP0/CPU0:router# show access-list ethernet-services l2_acl usage pfilter location
0/0/CPU0
Interface : GigabitEthernet0/0/0/9
Input ACL : l2_acl
Output ACL : N/A
Related Commands
DescriptionCommand
Creates a copy of an existing Ethernet services access list.copy access-list ethernet-service, on page 648
Sets conditions for an Ethernet services access listdeny (ES ACL), on page 650
Controls access to an interface.ethernet-service access-group, on page 653
Defines an Ethernet services (Layer 2) access list by name.ethernet-services access-list, on page 655
Sets conditions for an Ethernet services access list.permit (ES ACL), on page 657
Renumbers existing statements and increment subsequent
statements to allow a new Ethernet services access list
statement.
resequence access-list ethernet-service, on page
660
Displays the contents of current Ethernet services access
lists.
show access-lists ethernet-services, on page 662
Displays Ethernet services access list trace information.show access-lists ethernet-services trace, on page
666
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
669
Layer 2 Access List Commands
show access-list ethernet-service usage pfilter
To Next Page
Loading...
Need help?
General
