Mcast Sync Group: 224.10.10.1
Mcast Flags: 0x1
The following shows an example output of the show interface nve command.
RP/0/RSP0/CPU0:router(config)# show interface nve nve1 detail
Interface: nve1, State:up, encapsulation:VXLAN
source-interface: Lo1 (primary:1.1.1.1, secondary:1.1.1.2)
VNI mcast VNI state
10.10 239.1.1.1 UP
11.10 239.1.1.1 UP
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
679
VXLAN Commands
show nve interface