Examples
The following example shows how to enable debugging raw packet output for packets received at a specific
location:
RP/0/RSP0/CPU0:router#debug spanning-tree packet raw received location 0/0/CPU0
Mon Nov 15 21:16:42.570 PST
The following example shows how to enable debugging raw packet output for packets sent from a specific
interface:
RP/0/RSP0/CPU0:router#debug spanning-tree packet raw sent interface gigabitEthernet 0/0/0/1
Mon Nov 15 21:17:43.303 PST
Related Commands
DescriptionCommand
Enables debugging for sent and received MSTP packets.debug spanning-tree mst packet, on page 479
Enables MSTAG packet debugging.debug spanning-tree mstag packet, on page
483
Enables packet debugging for sent and received PVRSTAG
packets.
debug spanning-tree pvrstag packet, on page
489
Enables packet debugging for sent and received PVSTAG
packets.
debug spanning-tree pvstag packet, on page
491
Enables Resilient Ethernet Protocol (REP) Access Gateway
debugging commands.
debug spanning-tree repag packet, on page
493
Enters the MSTP configuration submodespanning-tree mst, on page 623
Enters the MST Access Gateway configuration submode.spanning-tree mstag, on page 625
Enters the Per VLAN Rapid Spanning Tree Access Gateway
(PVRSTAG) configuration submode.
spanning-tree pvrstag, on page 629
Enters the Per VLAN Spanning Tree Access Gateway
(PVSTAG) configuration submode.
spanning-tree pvstag, on page 631
Enters the Resilient Ethernet Protocol Access Gateway
(REPAG) configuration submode.
spanning-tree repag, on page 633
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
486
Multiple Spanning Tree Protocol Commands
debug spanning-tree packet raw
To Next Page
Loading...
Need help?
General
