This example shows sample output for the show l2vpn pw-class detail command:
RP/0/RSP0/CPU0:router# show l2vpn pw-class detail
Encapsulation MPLS, protocol LDP
Transport mode not set, control word unset (default)
Sequencing not set
Static tag rewrite not set
PW Backup disable delay: 0 sec
MAC withdraw message is sent over PW: no
IPv4 source address 1.1.1.1
This table describes the significant fields shown in the display.
Table 4: show l2vpn pw-class Command Field Descriptions
DescriptionField
Displays the name of the pseudowire class.Name
Displays the encapsulation type.Encapsulation
Displays the protocol type.Protocol
Related Commands
DescriptionCommand
Clears L2VPN forwarding counters.clear l2vpn forwarding counters, on page 72
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
196
Point to Point Layer 2 Services Commands
show l2vpn pw-class
To Next Page
Loading...
Need help?
General
